afc007
26-12-2010, 10:15
Motor Set up control explained
Recalculate in Motor Setup >> Command menu is to reset the motor position so that the motor knows where it is,
This is best done on your reference satellite,
To Access:-
Go to Motor Set up in Installation,
Command now select the options below by moving through the menu with your cursor >>>:-
Also in this menu you can set:-
Go to Sat Position (can be used to move the motor when setting up on a new reference satellite)
GOTO Centre (for setting up your reference satellite)
Limit Off (If the Motor stops before it reaches a satellite due to restrictions on limit previously set)
Set East Limit (sets as far as you want the motor to travel to prevent damage to dish)
Set West Limit as above,
Recalculate Position (when setting up reference satellite so that it is stored)
[attachment=0:36yvz3ev]donate banner.gif[/attachment:36yvz3ev]
Recalculate in Motor Setup >> Command menu is to reset the motor position so that the motor knows where it is,
This is best done on your reference satellite,
To Access:-
Go to Motor Set up in Installation,
Command now select the options below by moving through the menu with your cursor >>>:-
Also in this menu you can set:-
Go to Sat Position (can be used to move the motor when setting up on a new reference satellite)
GOTO Centre (for setting up your reference satellite)
Limit Off (If the Motor stops before it reaches a satellite due to restrictions on limit previously set)
Set East Limit (sets as far as you want the motor to travel to prevent damage to dish)
Set West Limit as above,
Recalculate Position (when setting up reference satellite so that it is stored)
[attachment=0:36yvz3ev]donate banner.gif[/attachment:36yvz3ev]